dynamicklion.blogg.se - Nikon camera control pro 2 newest update

#NIKON CAMERA CONTROL PRO 2 NEWEST UPDATE INSTALL#
#NIKON CAMERA CONTROL PRO 2 NEWEST UPDATE UPDATE#
#NIKON CAMERA CONTROL PRO 2 NEWEST UPDATE MANUAL#

Fixed an issue where the photo info display would show a fine-tuning value of “9” for photographs taken using WB bracketing when the total value was in fact greater than this amount.

Fixed an issue with the Viewfinder virtual horizon display freezing when certain operations were performed.

Fixed an issue that caused live view to stop updating if the AE-L/AF-L button was pressed when the display was zoomed in during color selection for the selective color special effect.

#NIKON CAMERA CONTROL PRO 2 NEWEST UPDATE MANUAL#

Fixed an issue that caused the flash level to be displayed in place of flash compensation in the photo info overview display for photographs taken with a flash using the Manual or Repeating flash options.

#NIKON CAMERA CONTROL PRO 2 NEWEST UPDATE UPDATE#

Update the camera firmware before updating to auto distortion control data version “L” 2.000 or later.Ĭhanges from “C” Firmware Version 1.00 to 1.01

The camera now supports auto distortion control data version “L” 2.000 and later.

Fixed an issue with the camera freezing when the Clean image sensor option was used.Ĭhanges from “C” Firmware Version 1.01 to 1.02.

Fixed issues with the virtual horizon displayed using the Viewfinder virtual horizon option.

Fixed an issue with the menus for some languages where continued scrolling would cause the camera to freeze.

Fixed an issue that sometimes caused the display to darken when images were viewed by pressing the (playback) button.

Reduced noise (horizontal lines) in movies shot with 1280×720 60p or 1280×720 50p selected for Frame size/frame rate.

Reduced the occurrence of white spots in movies.- Optimal exposure would sometimes not be achieved in photos taken in live view using a lens with electromagnetically controlled aperture (type E lenses).Ĭhanges from “C” Firmware Version 1.02 to 1.03.- When focus is adjusted by rotating the lens focus ring, the focus indicator in the viewfinder (and in live view, the focus point in the monitor) now flash to indicate when infinity or the minimum focus distance is reached.

- If the standby timer expires after focusing, the focus position will no longer change when the timer is reactivated.Added the following supports for AF-P lenses:.Ĭhanges from Previous Versions Changes from “C” Firmware Version 1.03 to 1.04 Fixed an issue that resulted in live view ending about 10 minutes after being started in Camera Control Pro 2 with selected for Custom Setting c4 > in the.Read the information below before proceeding.Ĭhanges from “C” Firmware Version 1.04 to 1.05.This update includes all changes made in previous updates.

#NIKON CAMERA CONTROL PRO 2 NEWEST UPDATE INSTALL#

You will not need to download or install this update if the firmware listed above is already installed. Before proceeding, select Firmware version in the camera setup menu and check the camera firmware version. This service supplies software that can be used to update the D7100 camera “C” firmware to version 1.05.Be sure you understand the terms of the agreement before beginning download. By selecting “Accept” and clicking “Download”, you are held to have accepted the terms and conditions of the agreement.

This software update program is for the customer-owned product listed above (the “affected product”), and is provided only on acceptance of the agreement listed below.